Hot water bag 250 ml, 1 pc.

Description

A heater in a rubber for heating body tissues. It is used for local body tissue and general heating of the patient.

The color is chosen randomly

Composition: rubber.

Volume: 250 ml

Terms of use:

1. Before use, check the heater and plug for wear and damage.
2. Wash the heater with warm soapy water and rinse under running water.
3. Fill 2/3 of the heater capacity with water whose temperature is not higher than 65°C. Hold the heater in an upright position by the neck and pour water slowly, avoiding hot water splashing.
   ATTENTION! DO NOT USE BOILING WATER. DO NOT OVERFILL THE HEATER WITH WATER, THIS MAY CAUSE RUPTURE OF THE HEATER. DO NOT FILL THE HEATER WITH HOT WATER FROM THE TAP, THIS MAY DAMAGE THE RUBBER OF THE HEATER.
4. Bleed the air out of the heater by pressing on it until water comes out.
5. Tighten the cap tightly.
6. Check for tightness: turn the heater with the plug down away from the body and click lightly.
7. Drain the heater.
8. The heater must be wrapped in a durable material or towel to avoid direct contact with the skin.
   ATTENTION! THE HEATER CAN CAUSE BURNS. AVOID PROLONGED DIRECT SKIN CONTACT. WARNING: It is not recommended to sit or lie on the heater or place heavy objects on it.
9. To prevent pigmentation or redness (especially with continuous and prolonged use of the heater), apply a moisturizer to the skin after using the heater.
10. It is necessary to take care of the correct position of the heater and often check the degree of warming of the skin, as burns are possible. The degree of warming of the skin under the heater is determined by hand.
11. After using the heater, pour out the water and hang it to dry with the plug removed until it is completely dry.

Storage conditions: Keep the heater suspended in a room with a temperature between 0 ºC and 25 ºC, away from heating devices by 1 m. Grease, petrol or other solvents and direct sunlight must not fall on the heater.